Step 10 - Complete The Installation Map; Complete The Installation Map; Alternative: Create Your Own Map; Step 11 - Connect The Pv Modules - enphase M215 Installation And Operation Manual

Microinverter

Hide thumbs Also See for M215:

Table of Contents

Step 10 – Complete the Installation Map

The Enphase Installation Map is a diagrammatic representation of the physical location of each microinverter

in your PV installation. The virtual array in Enlighten is created from the map you create. Use the blank map

on page 28 to record microinverter placement for the system, or provide your own layout if a larger or more

intricate installation map is required.

a . Each Enphase Microinverter has a removable serial number label located on the mounting

plate. Peel the removable serial number label from each Enphase Microinverter and affix it to the

respective location on the Enphase installation map (see map on page 28). Remember to keep

a copy of the installation map for your records.

a . Draw a top-down view of the array using the Array Map template (using either the grid on Side A

or the freeform area on Side B). Make sure to leave enough room to place the serial number

stickers.

b . When installing the microinverters, remove the serial number labels located next to the DC input

cables and place them in the correct order on your drawing of the system. Remember to keep a

copy of the installation map for your records.

Step 11 – Connect the PV Modules

NOTE: Completely install all microinverters and all

system AC connections prior to installing the PV

modules.

a . Mount the PV modules above the microinverters.

b . Mate the microinverters and PV modules as required.

Repeat for all remaining PV modules using one

microinverter for each PV module.

WARNING: The M215 should be paired only with a

60-cell PV module.

M215 Installation and Operation

141-00012 Rev 04

Table of Contents

Troubleshooting