Step 8: Complete The Installation Of The Junction Box; Step 9: Connect The Pv Modules - enphase IQ8P Installation And Operation Manual

Microinverters

Hide thumbs Also See for IQ8P:

Table of Contents

E. Hold the terminator body stationary with the screwdriver and turn only the hex nut to

prevent the conductors from twisting out of the separator.

NOTE: Turn only the hex nut to prevent conductors from twisting out of the separator.

F. Attach the terminated cable end to the PV racking with a

cable clip or tie wrap so that the cable and terminator do not

touch the roof.

WARNING: The terminator cannot be re-used. If you

unscrew the nut, you must discard the terminator.

Step 8: Complete the installation of the junction box

A. Connect the IQ Cable to the junction box.

B. Refer to the

Sample single-phase wiring diagram

in the following table.

WARNING: Electrical shock hazard. The DC conductors of this photovoltaic system are

ungrounded and may be energized.

A. If required, attach the DC bulkhead adaptors to the microinverters. Ensure they are fully

seated. Do not reverse the adaptor connections.

B. Connect the DC leads of each PV module to the DC input connectors of the corresponding

microinverter.

C. Check the LED on the connector side of the microinverter. The LED flashes six times when

DC power is applied.

D. Mount the PV modules above the microinverters.

Wire colors

L1-black

Enphase IQ8P Microinverters

for more information. Wire colors are listed

L2-red

January 2024

IOM-00002-1.0

Table of Contents