Check After Finishing Work; Stopping Engine - Komatsu PW130ES-6K Operation & Maintenance Manual

OPERATION
3. Operate park brake by using switch(4).
4. Lower the bucket horizontally until the bottom touches the
ground.
5. Set control lever pad safety lock (3) to the LOCK position.

CHECK AFTER FINISHING WORK

Check the engine water temperature, engine oil pressure and fuel
level on the monitor.

STOPPING ENGINE

NOTICE
If the engine is abruptly stopped before it has cooled
down, engine Iife may be greatly shortened. Consequently,
do not abruptly stop the engine apart from an emergency.
In particular, if the engine has overheated, do not abruptly
stop it but run it at medium speed to allow it to cool gradu-
ally, then stop it.
1. Run the engine at low idling speed for about 5 minutes to
allow it to gradually cool down.
2. Turn the key in starting switch (1) to the OFF position and
stop the engine.
3. Remove the key from starting switch (1).
OPERATION
OFF
AM089160A
137