Check After Stopping Engine; Locking; Overload Warning Device; Handling The Wheels - Komatsu PW130ES-6K Operation & Maintenance Manual

OPERATION

CHECK AFTER STOPPING ENGINE

1. Walk around the machine and check the work equipment,
paint work, and undercarriage, and check also for leakage of
oil or water. If any abnormalities are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean
out any paper and debris to avoid a fire hazard.
4. Remove any mud stuck to the undercarriage.

LOCKING

Always lock the following places.
Door of operator's cab.
(1)
Always remember to close the window.
(2) Fuel tank filler port
(3) Engine hood
(4) Tool box cover
(5) Battery room door (left side of machine)
REMARK
Use the starting switch key to open and close all these
places.

OVERLOAD WARNING DEVICE

Excavators are provided with this device to warn the operator
about tipping over while lifting loads. A buzzer will sound when
the machine is in LO mode. and the machine nears its lifting
capacity
NOTE: Only conduct lifting operations in LO mode as the over-
load warning system is only active in this mode.

HANDLING THE WHEELS

Incorrect handling of wheels and tyres can result in serious
injury or death.
Particular care is required when working on twin wheel
assemblies.
138
WARNING
OPERATION