Check Before Starting - Komatsu PW130ES-6K Operation & Maintenance Manual

SERVICE PROCEDURE

CHECK BEFORE STARTING

CHECK COOLANT LEVEL, ADD WATER
Do not open the radiator cap unless necessary. When check-
ing the coolant, always check the radiator reserve tank when
the engine is cold.
1. Open the rear door on the left side of the machine and check
that the cooling water level is between the FULL and LOW
marks on radiator reserve tank (1) (shown in the diagram on
the right).
If the water level is low, add water through the water filler of
reserve tank (1) to the FULL level.
2. After adding water, tighten the cap securely.
3. If the reserve becomes empty, first inspect for water leaks
and then fill the radiator and the reserve tank with water.
CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL
1. Open the engine hood.
2. Remove dipstick (G) and wipe the oil off with a cloth.
3. Insert dipstick (G) fully in the oil gauge pipe, then take it out
again.
4. The oil level should be between the H and L marks on dipstick
(G). If the oil level is below the L mark, add engine oil through
oil filler (F).
For details of the oil to use, "USE FUEL, COOLANT AND
LUBRICANTS ACCORDING TO AMBIENT TEMPERA-
TURE" on page 173
5. If the oil is above the H mark, drain the excess engine oil from
drain valve (P), and check the oil level again.
6. If the oil level is correct, tighten the oil filler cap securely and
close the engine hood.
REMARK
Ensure that the machine is level when checking oil level.
200
WARNING
MAINTENANCE.
AM090180
AD052340A