Dmx Mode; Set The Starting Dmx Address; Select The Dmx Channel Mode; Select The Dmx Run Mode - Blizzard Lighting STILETTO I7 Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Set the Starting DMX Address:

1.) Navigate the main menu until you reach Set.
2.) Push the <OK> button, then navigate to DMX Address and press <OK>.
3.) Use the <UP/DOWN> buttons to select a DMX channel from 001-512.
4.) Press the <OK> button to confirm.

Select the DMX Channel Mode:

1.) Navigate the main menu until you reach Set.
2.) Push the <OK> button, then navigate to Channel Mode and press <OK>.
3.) Use the <UP/DOWN> buttons to select either 27CH or 55CH.
4.) Press the <OK> button to confirm.

Select the DMX Run Mode:

1.) Navigate the main menu until you reach Set.
2.) Push the <OK> button, then navigate to Run Mode and press <OK>.
3.) Use the <UP/DOWN> buttons to select DMX.
4.) Press the <OK> button to confirm your selection of DMX mode.
Auto, Sound Active, & Manual Adjustments:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.

Auto Mode:

1.) Navigate the main menu until you reach Set.
2.) Push the <OK> button, then navigate to Run Mode and press <OK>.
3.) Use the <UP/DOWN> buttons to select Auto 1, Auto 2, or Auto 3.
4.) Press the <OK> button to confirm your selection of auto mode.

Sound Active Mode:

1.) Navigate the main menu until you reach Set.
2.) Push the <OK> button, then navigate to Run Mode and press <OK>.
3.) Use the <UP/DOWN> buttons to select Sound 1, or Sound 2.
4.) Press the <OK> button to confirm your selection of sound active mode.

Loss of DMX Setting:

If the DMX signal is lost, fixture will revert to this setting.
1.) Navigate the main menu until you reach Set.
2.) Push the <OK> button, then navigate to No DMX Signal and press <OK>.
3.) Use the <UP/DOWN> buttons to select Keep (hold), or Clear (blackout).
4.) Press the <OK> button to confirm your selection.

Invert Pan/Tilt, Auto Position Correction

1.) Navigate the main menu until you reach Set.
2.) Push <OK>, then navigate to Invert Pan or Invert Tilt and press <OK>.
3.) Use the <UP/DOWN> buttons to select On or Off.
4.) Press the <OK> button to confirm your selection.
5.) In the same manner, you can turn On/Off Pan-Tilt Encoder (Pan/Tilt position correction.)

Dimming Curves

1.) Navigate the main menu until you reach Set.
2.) Push <OK>, then navigate to Dimmer Curve and press <OK>.
3.) From here, you can select LINE (linear), SCUR (s-curve), INSQ (inverse square law curve),
or SQUA (square law curve).
4.) Press the <OK> button to confirm your selection.

Reset Functions

1.) Navigate the main menu until you reach Set.
2.) Push <OK>, then navigate to Load Default and press <OK>.
Stiletto™ I7 User Manual - Rev. A
Page 14
(c) 2016 Blizzard Lighting, LLC