Configuring The Switchover To Spt; Configuring Bidir-Pim - HP MSR1002-4 Configuration Manual

To configure multicast source registration:
Step
1. Enter system view.
2. Enter PIM view.
3. Configure a PIM register
policy.
4. Configure
calculate
based on the entire register
message.
5. Configure
suppression time.

Configuring the switchover to SPT

CAUTION:
If the device is an RP, disabling the switchover to SPT might cause multicast traffic forwarding
failures on the source-side DR. When disabling the switchover to SPT, make sure you fully
understand its impact on your network.
Both the receiver-side DR and RP can monitor the traffic rate of passing-by multicast packets and
thus trigger a switchover from RPT to SPT. The monitor function is not available on switches.
To configure the switchover to SPT:
Step
1. Enter system view.
2. Enter PIM view.
3. Configure the RPT to SPT
switchover.
NOTE:
If the multicast source information is learned through MSDP, the device switches to SPT
immediately after it receives the first multicast packet, regardless of the traffic rate threshold.

Configuring BIDIR-PIM

This section describes how to configure BIDIR-PIM.
Command
system-view
pim
vpn-instance-name ]
register-policy ipv4-acl-number
the device to
the checksum
register-whole-checksum
the register
register-suppression-timeout
interval
Command
system-view
pim
vpn-instance-name ]
spt-switch-threshold
{ traffic-rate
infinity
ipv4-acl-number ]
[ vpn-instance
vpn-instance
[
| immediacy |
} [ group-policy
111
Remarks
N/A
N/A
By default, no PIM register
policies exist, and all PIM register
messages are regarded legal.
By default, the device calculates
the checksum based on the
header of a register message.
The default setting is 60 seconds.
Remarks
N/A
N/A
By default, the first multicast data
packet triggers the RPT to SPT
switchover.
The traffic-rate argument is not
supported on switches.