Table of Contents
Advertisement
Remove the FlexibleLOM.
6.
To replace the component, reverse the removal procedure.
Accelerator
To remove the component:
Power down the server (on page 10).
1.
Disconnect all peripheral cables and power cords from the rear panel.
2.
Remove the server (on page 11).
3.
Remove the access panel (on page 12).
4.
CAUTION: To avoid damage to the accelerator, do not touch the edge where the accelerator
aligns with the water wall.
Remove the Intel Xeon Phi 7120D coprocessor accelerator.
5.
To replace the component, reverse the removal procedure.
Accelerator riser board
Power down the server (on page 10).
1.
Disconnect all peripheral cables from the server.
2.
Removal and replacement procedures 44
Advertisement
Table of Contents
