Table of Contents
Advertisement
Remove the server (on page 11).
3.
Remove the access panel (on page 12).
4.
Remove the accelerators ("Accelerator" on page 44).
5.
Remove the accelerator riser board:
6.
Disconnect the nine screws securing the accelerator riser board to the tray.
a.
To disconnect the riser board, slide the riser out from the system board, and then lift up to remove
b.
it.
To replace the component, reverse the removal procedure.
Memory options
The memory subsystem in this server can support the following regular RDIMMs with the Intel Xeon
E5-2600 v3 processors:
HPE 8 GB (1x8 GB) Single Rank x4 DDR4-2133
o
HPE 16 GB (1x16 GB) Dual Rank x4 DDR4-2133
o
The server supports single- and dual-rank PC4-2133 (DDR4-2133) RDIMMs with speeds operating at up
to 2133 MT/s.
Speed and capacity
DIMM rank
Single
Dual
Depending on the processor model, and the number of DIMMs installed, the memory clock speed can be
reduced to 1600 MT/s.
Populated DIMM speed (MT/s)
Processor type
Intel Xeon E5-2600 v3
Intel Xeon E5-2600 v3
DIMM capacity (GB)
8
16
DIMM rank
1 DIMM per channel
Single (8 GB)
2133
Dual (16 GB)
2133
Native speed (MT/s)
2133
2133
Removal and replacement procedures 45
2 DIMMs per channel
2133
2133
Advertisement
Table of Contents
