Slide the drive into the drive cage backplane, aligning the drive screw holes with the drive cage
a.
screw holes.
Install the four drive anchor screws.
b.
Connect the drive cables.
c.
Install the drive cage.
2.
Install the access panel (on page 13).
3.
Install the server (on page 14).
4.
Connect peripheral devices to the server.
5.
Power up the server
6.
Front panel I/O board
CAUTION: Replace all cut cable ties during a removal and replacement procedure. Failure to
do so results in improper airflow that can lead to thermal damage.
("Powering up the
server" on page 15).
Removal and replacement procedures 40