Replacing The Battery - IBM TotalStorage IP Storage 200i 110 Installation Manual

Replacing the battery

IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following safety guidelines.
CAUTION:
<2–16> When replacing the lithium battery, use only IBM Part Number
33F8354 or an equivalent type battery recommended by the manufacturer. If
your system has a module containing a lithium battery, replace it only with
the same module type made by the same manufacturer. The battery contains
lithium and can explode if not correctly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note: For translations of this safety notice, refer to Safety Information, which can
Note: In the U.S., call 1 800 BM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a correct manner. To
order replacement batteries, call 1 800 772-2227 within the United States.
Before you begin:
v Review the safety precautions listed in "Appendix C. Safety notices" on page 47.
v Follow any special handling and installation instructions supplied with the
Note: After you replace the battery, you must reconfigure your appliance and reset
22
IBM TotalStorage IP Storage 200i Models 110 and 210 Installation Guide
!
be found on the support support Publications and Code CD that was shipped
with your appliance.
replacement battery.
the system date and time.