Table of Contents
Advertisement
Performing initial configuration
Before the IP Storage 200i can be fully functional as an iSCSI server, you must
complete a set of required configuration tasks from the Web-based
appliance-management utility, called the Administrative Console. Because the
appliance is headless, configuration must be completed from another machine in
the same network, known as the management workstation.
This section steps you through the following procedures to perform the minimum
required configuration. Refer to the IBM TotalStorage IP Storage 200i
Administrator's Guide for information about configuring your storage settings.
1. Accessing the Administrative Console
2. Logging in to the Administrative Console
3. Taking control of the Administrative Console
4. Configuring the network
5. Creating a logical drive
6. Creating and assigning VLUNs
Note: After you complete the required configuration tasks, it is important to back up
Prerequisites
The IP Storage 200i requires a Web browser to access the Administrative Console.
The supported Web browsers are Microsoft Internet Explorer 5.0 (and later) and
Netscape 4.5 (and later) running on Windows 98, Windows Millennium, Windows
NT, or Windows 2000. An Internet connection is recommended.
Note: The IP Storage 200i requires a direct connection to the Internet from the
The Administrative Console requires the following plug-ins, which are available
online at java.sun.com:
v Java
v Sun Java Plug-in 1.3 or later
Note: The Sun Java Plug-in 1.3 is a product of Sun Microsystems, Inc. IBM does
Configuration files are backed up and recovered from a local FTP server. This FTP
server must support anonymous FTP. You can also update the system image from
this FTP server.
32
IBM TotalStorage IP Storage 200i Models 110 and 210 Installation Guide
Note: Wait approximately 15 seconds after disconnecting the power cords for
your appliance to stop running. Watch for the Power-on LED on the
operator information panel to stop blinking.
your configuration. See the IBM TotalStorage IP Storage 200i Administrator's
Guide for instructions on backing up your configuration files.
browser, not through a proxy server. If a proxy server is used for the Internet,
the IP Storage 200i must be excluded.
™
Swing 2
not distribute, support or maintain the Sun Java Plug-in 1.3, and your use of
this product is subject to license terms and conditions imposed by Sun
Microsystems, Inc. Contact Sun Microsystems, Inc. directly if you have any
questions about this product.
Advertisement
Table of Contents
