Powering Off The Appliance - IBM TotalStorage IP Storage 200i 110 Installation Manual

3. Check that the Power-on LED is on and the Information LED and System Error

Powering off the appliance

CAUTION:
<2–19> The power control button on the device and the power switch on the
power supply do not turn off the electrical current supplied to the device. The
device also might have more than one power cord. To remove all electrical
current from the device, ensure that all power cords are disconnected from
the power source.
Note: For translations of this safety notice, refer to Safety Information, which can
Attention:
of data. Instead, it is recommended you use the Administrative Console to shut
down. Refer to the IBM TotalStorage IP Storage 200i Administrator's Guide for
instructions.
To power off the appliance:
1. Review the safety precautions in "Safety precautions" on page ix.
2. Press and hold the power button for 4 seconds to causes an immediate
3. Disconnect the appliance power cords from the electrical outlets.
LED are both off.
Note: Depending on the system status, other LEDs may be on.
3 4
OK
TX
100 LINK
MB OK
RX
1
Information LED
2
System Error LED
3
Power-on LED
4
POST Complete (OK) LED
Note: This LED is not enabled on the appliance. For system status,
observe the Information LED and System Error LED. These
LEDs are both off when no problems are detected during startup.
If a problem is detected during the diagnostics, refer to the IBM TotalStorage IP
Storage 200i Administrator's Guide.
be found on the Publications and Code CD that was shipped with your
appliance.
Powering off the appliance using the power button can result in a loss
shutdown of the appliance and place the appliance in standby mode.
Chapter 2. Installation procedures
31