Table of Contents
Advertisement
7. Turn the DIMM so that the pins align correctly with the connector. Note the
notches in the DIMM edge that key the DIMM to the connector.
8. Insert the DIMM into the connector by pressing on one end of the DIMM and
then on the other end of the DIMM. Be sure to press straight into the
connector. Be sure that the retaining clips snap into the closed position.
Note: DIMM slots 1 and 4 must be filled. You can place additional memory in
slots 2 and 3.
1
Memory module 1
2
Memory module 2
3
DIMM slot 1
4
DIMM slot 2
5
DIMM slot 3
6
DIMM slot 4
Figure 4. Installing a DIMM
9. Make sure that the retaining clips are in the closed position. If a gap exists
between the DIMM and the retaining clips, the DIMM has not been correctly
seated. In this case, open the retaining clips and remove the DIMM; then,
reinsert the DIMM.
10. Repeat steps 5 on page 16 through 9 for the remaining DIMM.
Replacing the cover
This section describes how to replace the cover on the Model 110 and Model 210.
Replacing the Model 110 cover: To replace the left-side cover:
1. Align the cover with the left side of the appliance, about 25 mm (1 in.) from the
front of the engine; place the bottom of the cover on the bottom rail of the
chassis.
2. Insert the tabs at the top of the cover into the slots at the top of the engine.
6
Chapter 2. Installation procedures
17
Advertisement
Table of Contents
