Table of Contents
Advertisement
Accessing the Administrative Console
You can access the Administrative Console from the management workstation
through the Gigabit Ethernet (data port) or Service Ethernet (service port) . The
data port is the primary port used for storage traffic and configuration purposes. The
service port is used only for service purposes. No storage traffic occurs over the
service port.
Note: It is recommended that you use the service port for initally configuring the IP
Accessing the Administrative Console through the Service
Ethernet
The Service Ethernet is preconfigured with IP address 192.9.200.1. The
Administrative Console must be configured on the 192.9.200 subnet to use the
preconfigured IP address.
Administrative
Console
Note: It is recommended that you use the default IP address of the Service
To access the Administrative Console through the Service Ethernet
1. Launch a Web browser from the management workstation.
2. Point the browser to the following address. Note that this address is
When the workstation connects successfully to the appliance, a pop-up window
appears for login and password. Proceed to "Logging in to the Administrative
Console" on page 35.
Storage 200i.
LAN
(same subnet)
100-Mb
switch
®
®
Windows NT , Windows 98,
Millenium, and 2000
Internet Explorer or Netscape
(direct connection, not proxy)
Java Plug-in 1.3 (see java.sun.com)
http://192.9.200.1:1959/IBM200i
Ethernet; however, you can change the default IP address from the serial
console by typing enet and pressing Enter at the svc> prompt, and following
the instructions on the screen. (See the IBM TotalStorage IP Storage 200i
Administrator's Guide for instructions on setting up the serial console.)
case-sensitive.
http://192.9.200.1:1959/IBM200i
Client
IBM
IP Storage
Gigabit
Service
Gigabit
port
port
Note:
The Service port and
Gigabit port
must be on
different subnets.
Chapter 2. Installation procedures
Client
LAN
switch
33
Advertisement
Table of Contents
