Table of Contents
Advertisement
!
≥18 kg (37 lbs)
CAUTION:
<2–17> Use safe practices when lifting.
!
CAUTION:
<2–18> Do not place any object weighing more than 82 kg (180 lb) on top of
rack-mounted devices.
!
CAUTION:
<2-20> Do not place your fingers around the rack-support wheels when
lowering the engine onto the slide rails. Ensure that your fingers do not
become pinched between the wheels and the rail.
Note: For translations of this safety notice, refer to Safety Information, which can
be found on the Publications and Code CD that was shipped with your
appliance.
To install the Model 210 in a rack:
1. Review the safety precautions in "Safety precautions" on page ix.
2. Remove all hard disk drives before installing the engine in a rack to lighten the
weight of the engine:
a. Pull the drive tray handle to the open position (perpendicular to the hard
drive) to disengage the hard disk drive connector from the backplane at the
back of the drive bay.
b. Wait approximately 30 seconds to allow the hard disk drive to spin down.
c. Pull the hot-swap hard disk drive assembly from the drive bay.
3. Remove the rack doors and the side panels during the installation, if necessary.
≥32 kg (70.5 lbs)
Chapter 2. Installation procedures
≥55 kg (121.2 lbs)
7
Advertisement
Table of Contents
