To Set Bits/Parity; To Set Beep - Denver Instrument P-114 Operation Manual

To set baud rate:
1. Press MENU.
2. Press until "System" is highlighted, press the
3. Press the until "RS232" is highlighted, press the
4. When "Baud" is displayed, press
5. Press the or
press ENTER.
6. Press TARE to return to the measurement screen or
to the main menu.

To set bits/parity:

1. Press MENU.
2. Press until "System" is highlighted, press the
3. Press the until "RS232" is highlighted, press the
4. Press the until "Bits/Parity" is displayed, press
5. Press the or
and press ENTER.
6. Press TARE to return to the measurement screen or
to the main menu.
Format is data bits, parity, stop bits, where:
N = none
Note:
E = even
Memo:
O = odd
To set print Echo:
1. Press MENU.
2. Press until "System" is highlighted, press the
3. Press the until "RS232" is highlighted, press the
4. Press the until "Echo" is displayed, press
5. Press or to select "On"or "Off" and press ENTER.
6. Press TARE to return to the measurement screen or
to the main menu.
Speaker
Set beep:
You can select if the balance will beep with each key press.
1. Press MENU.
2. Press until "System" is highlighted, press the
3. Press the until "Speaker" is highlighted, press the
4. Press the or
and press ENTER.
5. Press TARE to return to the measurement screen or
to the main menu.
.
until the desired baud rate is highlighted and
until the desired serial setting is highlighted
until the desired beep setting is highlighted
31
.
.
to return
.
.
.
to return
.
.
.
to return
.
.
to return