System; To Set Password; Rs232 - Denver Instrument P-114 Operation Manual

System

Security
This balance can be set to prevent access to the menu and to not
allow calibration.

To set password:

1. Press MENU.
2. Press until "System" is highlighted, press the
3. Press the until "Security" is highlighted, press the
4. Enter password.
a. Press or
b. Press to move to the next digit.
c. Repeat these steps until the desired password is displayed.
d. Press ENTER and accept to return to the measurement
screen.
• When the menu key or calibration key is pressed, the password
screen will be displayed.
• Enter the password to turn off security.
• To set security again, follow the "To set password" steps above.

RS232

This balance has a bi-directional RS232 port which enables com-
munication with other serial devices such as a printer or computer.
In order to communicate with another device the baud rate, parity,
data bits and stop bits must be the same on both instruments.
Security
RS232
Speaker
Defaults
Software
Platform
Internal Cal
Display
Your Pinnacle series balance requires the use of a custom, non-
standard communication cable available from Denver Instrument,
part number 902225.1. If you wish to manufacture your own cable,
please refer to the pin-out below. Pin 9 must not be connected.
Serial Cable Pin-outs:
Pinnacle Series
DB-9 (male)
TxD 2
RxD 3
Ground 5
until the desired digit is selected.
Baud
Bits/Parity
Echo
Standard RS-232 Connector
30
.
.
DB-9 (female)
TxD 2
RxD 3
Ground 5