Target/Percentage Weighing - Denver Instrument P-114 Operation Manual

Target/Percent Weighing
Mode
This application allows you to obtain weight readout in percent
proportional to a reference weight. You can also set limits for the
reading with plain-language limit values.
The balance will display both the percentage and the total weight
in units set as the primary units.
Pressing the TARE key will exit from any menu without sav-
ing changes.
Note:
Memo:
The total sample weight must not exceed the balance
capacity.
Note:
Memo:
Entering target mode:
1. Press MENU.
2. When "Applications" is highlighted, press the
3. Press the until "Target Weigh" is highlighted and then
press .
4. Enter the Target weight:
a. Using the move the cursor to the correct digit, in relation-
ship to the decimal place to be changed.
b. Press or
c. Press to move to the next digit.
d. Repeat these steps until the correct target weight (in units
selected as primary) is displayed.
e. Press ENTER .
Beginning to percent weighing:
1. "Target Weigh" should be displayed on screen. If not follow
steps to "entering target mode".
2. Remove all items from the pan, except a container if necessary.
3. Press the TARE key.
4. Add or subtract parts and a percentage of the weight as well as
the combined weight is displayed.
5. Taring the balance will change the percentage to zero.
To quit Target Mode, select "Normal Mode" in application
menu.
Note:
Memo:
until the desired unit is selected.
15
.