Adjusting The Shift Pedal - Yamaha XVZ13TF 1999 Service Manual

BLEEDING THE HYDRAULIC BRAKE SYSTEM/
3-41

ADJUSTING THE SHIFT PEDAL

2. Bleed:
a. Add the recommended brake fluid to the
b. Install the diaphragm (brake master cylinder
c. Connect a clear plastic hose 1 tightly to the
A Front
B Rear
d. Place the other end of the hose into a con-
e. Slowly apply the brake several times.
f. Fully squeeze the brake lever or fully de-
g. Loosen the bleed screw.
h. Tighten the bleed screw and then release the
i. Repeat steps (e) to (h) until all of the air
j. Tighten the bleed screw to specification.
k. Fill the reservoir to the proper level.
After bleeding the hydraulic brake system,
check the brake operation.
EAS00136
ADJUSTING THE SHIFT PEDAL
1. Check:
3-41
S hydraulic brake system
proper level.
reservoir or brake fluid reservoir).
bleed screw 2 .
tainer.
press the brake pedal and hold it in position.
This will release the tension and cause the
brake lever to contact the throttle grip or the
brake pedal to fully extend.
brake lever or brake pedal.
bubbles have disappeared from the brake
fluid in the plastic hose.
Bleed screw
6 Nm (0.6 mSkg)
Refer to "CHECKING THE BRAKE FLUID
LEVEL".
WARNING
S shift pedal position
Check the shift pedal rod length a .
If the position is incorrect ! Adjust.
Shift pedal rod length:
26.8 mm
CHK
ADJ