Yamaha XVZ13TF 1999 Service Manual page 219

CRANKCASE
6. Lubricate:
S crankshaft journal bearings
(with the recommended lubricant)
Recommended lubricant
Engine oil
7. Apply:
S sealant
(onto the crankcase mating surfaces)
Yamaha bond No. 1215
90890-85505
Quick Gasket
ACC-11001-15-01
NOTE:
Do not allow any sealant to come into contact
with the oil gallery or crankshaft journal bear-
ings. Do not apply sealant to within 2 X 3 mm of
the crankshaft journal bearings.
8. Install:
S upper crankcase 1
(onto the lower crankcase 2 )
CAUTION:
Before tightening the crankcase bolts, make
sure that the transmission gears shift cor-
rectly when the shift drum assembly is
turned by hand.
9. Install:
S final drive assembly
Refer to "MIDDLE GEAR".
NOTE:
The arrow on the final drive assembly must
point towards the upper crankcase.
10. Install:
S middle driven shaft bearing housing bolts
NOTE:
The bolt with the washer goes in the lower right
hole a of the middle driven shaft bearing hous-
ing.
Middle driven shaft bearing
housing bolt
30 Nm (3.0 mSkg)
4-75
ENG