Abbott i-STAT 1 System Manual page 279

1.13: Run the Electronic Simulator in the handheld. When the simulator finishes, PASS
should be displayed.
Note: If PASS is not displayed, re-run the Electronic Simulator. If the repeated Electronic Simu-
lator attempt fails, contact APOC Technical Support. For additional information on running the
electronic simulator, see Section 14 of the i-STAT 1 System Manual.
Congratulations. The process for updating the first
Review the options below for additional instructions.
If there are no additional handhelds to update, the process is complete:
• Click the
• Close all other open boxes
• Confirm all messages
If there are additional handhelds to update via the same Network Downloader address:
• Click Close
• Click Update
• Repeat steps 1.10 through 1.13.
If there are additional handhelds to update via a different Network Downloader address:
• Click Close
• Repeat steps 1.9 through 1.13.
If your facility uses Central Data Station:
• Proceed to and perform step 2.6.
2. UPDATING THE i-STAT 1 HANDHELD USING THE CDS VERSION 5
CUSTOMIZATION WORKSPACE WITH A SERIAL OR NETWORK DOWNLOADER
OR DOWNLOADER / RECHARGER, OR DRC-300
2.1: Before starting the process, make sure all the required equipment / informa-
tion is available:
• Computer with CDS Version 5 application
• i-STAT System Equipment
(1) i-STAT 1 handheld
(2) Serial or Network Downloader, Downloader / Recharger, or DRC-300
Note: These instructions assume that the Serial and Network Downloader types being
used for the update process are already installed and in-use at the customer's facility.
(3) The latest i-STAT Software and Documentation CD
(4) Electronic Simulator
2.2: Close all open programs on the computer including i-STAT Central Data Station.
2.3: Before inserting the i-STAT Software and Documentation CD, check that the
JAMS application and CLEW match the Product Update.
i-STAT 1 Handheld is complete.
button in the upper right corner of the software screen
Art: 725768-00E Rev. Date: 04-Jan-12
5