Printing Directly From I-Stat 1 Handheld; Powering The I-Stat Printer Using The Ac Adapter And Power Cord - Abbott i-STAT 1 System Manual

Hide thumbs Also See for i-STAT 1:

Table of Contents

8. Slide the battery door back onto the compartment until it closes and locks into place.

9. Turn the printer over, plug it back into the AC power adapter, and charge the new battery in the

printer for a minimum of 3 hours before use.

Note: If the rechargeable battery is removed or becomes exhausted, it is still possible to print at reduced

speed using the AC power adapter.

1. Connect the power cord to the AC adapter as shown.

2. Plug the round connector from the AC adapter into the 12VDC port on the back of the i-STAT

3. Plug the power cord into a wall outlet.

PRINTING DIRECTLY FROM THE i-STAT 1 HANDHELD

1. Ensure that the printer is turned on and that the POWER indicator is green.

2. Align the handheld's IR communication window with the printer's IR LED window. Generally, the

printer must be within 1 to 5 inches (2.5 – 12.7 cm) of and not too close to the handheld.

3. Display the results to be printed on the handheld.

4. Press the

5. If printer is not powered from a wall outlet using the AC adapter, turn printer off.

key on the handheld. Do not move handheld or printer until printing is complete.

Art: 714369-00H

Rev. Date: 03-Aug-12

Troubleshooting