Table of Contents
Advertisement
STEP 12A INSTALL OVERLAY PANELS
Install door panels:
• Open door to 90°. Remove the 6 Phillips-head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, then lift off
the trim. Retain the screws.
• Slide the overlay panel into the door trim.
Dispenser Models Only:
• The dispenser controls protrude beyond the face
of the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim.
• Reinstall the top trim piece with the screws.
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original screws
in the REAR screw holes.
• Secure the handle to the door using the FRONT
screw holes.
• Follow the same procedures to install the opposite panel.
• Check to be sure the handles are evenly aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
Installation Instructions
16
Door Trim
Handle
Trim
Refrigerator
Door
Move
Forward
For 19 mm
Panel
Supplied Handle
Shown in Overlay
Panel Position
to Secure Handle
Use Rear Holes
to Secure Trim
Use Front Holes
Advertisement
Table of Contents
