Table of Contents
Advertisement
THE INSTALLATION SPACE
*Finished Width
152 mm
2146 mm Max.
Electrical
2121 mm Min.
Area
Finished
Opening
610 mm
127 mm
Water Supply
89 mm
*Finished cutout width must be:
1054 mm for 42" Models
1207 mm for 48" models
Water And Electrical Locations
The opening must be prepared with the electrical and
water supply located as shown.
The cutout depth must be at least 610 mm
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot
exceed the 610 mm installation depth shown. The top
case trim overlaps the bottom of the soffit.
Additional Specifications
• 220 to 240 volt, 50 Hz., 4.5 amps power supply is
required. An individual properly earthed branch circuit
or circuit breaker is recommended. Install a properly
earthed electrical receptacle recessed into the back
wall. Electrical outlet must be located on rear wall as
shown.
• Use the supplied water line kit or GE SmartConnect
Refrigerator Tubing kit to connect the water line
on the refrigerator to the house water supply.
Installation of an easily accessible shut-off valve
in the water line is required.
Design Guide
42" Models, 457 mm
48" Models, 508 mm
127 mm
1905 mm From
Floor to Bottom
of Electrical
Area
127 mm
89 mm
™
DIMENSIONS AND CLEARANCES
Case Width:
1041 mm for 42" Models
1194 mm for 48" Models
*2121 mm
at Rear
Depth Including Handles:
683 mm Framed Models
729 mm Professional Models
Product Clearances
These refrigerators are equipped with a 2-position
doorstop. The factory-set 130° door swing can be
adjusted to 90° if clearance to adjacent cabinets or
walls is restricted.
130° Door Swing
A
330 mm
Allow minimum clearances for the freezer door
(Dimension A) and fresh food door (Dimension B)
for a full 130° door swing and to allow for pan removal.
Models
A
42"
330 mm
48"
381 mm
For a 90° door swing, allow 101.6 mm min. clearance
to a wall for framed and stainless steel models. Allow
127 mm min. clearance for professional series models.
If the 90° doorstop position is used, pan access is
maintained, but pan removal is restricted.
See the illustrations on pages 4 and 5 to determine door
swing interaction with adjacent cabinets or countertops.
3
645 mm Framed Models
654 mm Stainless Steel Models
Case Depth
* Shipping height.
The refrigerator can
be adjusted to fit into a
cutout that is 2121 min.
*2134 mm
to 2146 mm max. height.
From Floor
Note that the top case
to Top Frame
trim at the front is 13 mm
higher and will overlap
upper cabinetry or soffit.
Use leveling legs and
wheels for a maximum
25 mm height adjustment.
Frame to Frame:
1067 mm for 42" Models
1219 mm for 48" Models
90° Door Swing
B
483 mm
102 mm Min.
102 mm Min.
to Wall
B
C
483 mm
676 mm
508 mm
727 mm
606 mm
606 mm
Behind
Behind
Frame
Frame
676 mm
C
to Wall
Advertisement
Table of Contents
