Step 15, Connect Power; Step 16 Start Icemaker; Step 17 Install Toekick - Monogram ZPB480D Installation Instructions Manual

Side-by-side refrigerators
Hide thumbs Also See for ZPB480D:
Table of Contents

Advertisement

STEP 15 CONNECT POWER, CLOSE
GRILLE PANEL
• Open the grill panel.
• Plug in the power cord (if necessary) by reaching
into the opening next to the water filter. If access is
too tight, remove the 2 screws holding the water
filter bracket and move aside. Plug in the power cord
and secure the bracket with the original screws.
Bracket
Screws
Master Light
Switches
• Check to make sure power to refrigerator is on
by opening refrigerator door to see if interior lights
are on.
• The temperature controls are preset at 3°C for
the fresh food section and -18°C for the freezer.
• Allow 24 hours to stabilize before making
adjustments.

STEP 16 START ICEMAKER

Green Power Light
• Flip the switch to I (ON). The icemaker will begin
operation automatically.
• Be sure nothing interferes with the sweep of the
feeler arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, set the switch to O (OFF).
Installation Instructions
Electrical
Outlet Access
Power Switch
Feeler Arm

STEP 17 INSTALL TOEKICK

• Locate the supplied toekick (shipped taped to
the side of the refrigerator). Install with the 2 screws
provided. Adjust to the desired height and tighten
the screws.
• A custom toekick can be installed to match
or complement the surrounding cabinetry.
Use the supplied toekick as a template
to cut the shape.
6 mm or Thicker Toekick
1/4" or Thicker Toekick
INSPECT FINAL INSTALLATION
Check door alignment
Stand back away from the refrigerator to inspect
the final installation.
• Check to be sure the handles are evenly aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
• Shipping or the addition of heavy door panels
may have caused the doors to move slightly out
of alignment.
• If necessary, the fresh food door may be adjusted up
or down to align with the freezer door.
• Use a 5/16" wrench to adjust the hinge pin as shown.
19
Supplied Toekick
Supplied Toekick
Door Out of
Alignment
Bushing
D o o r H i n
C a s e H in g
5/16" Wrench
Raise
g e
e

Advertisement

Table of Contents
loading

Table of Contents