STEP 9 SECURE REFRIGERATOR
TO CABINETRY
Whenever possible, perform this step for anti-tip
security or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access the case trim.
• Drill a hole in the trim and drive a 6 mm diameter
screw through the trim into the adjacent cabinet.
• Follow the same procedure on the opposite side.
Raise Grille Panel
to Stop Position
Drive Screws
Through Case Trim Into
Adjacent Cabinets
STEP 10 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
90˚
Interior
Hinge
• Open the door to view the bottom hinge.
Note the door stop pin locations. The pin is factory-
installed in the 130° position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 90° position.
Installation Instructions
130˚
Door
STEP 11 INSTALL GRILLE PANEL
(for Custom Panel Models only)
To insert the framed or overlay panel into the grille:
• Raise the grille panel to the stop position.
Loosen
Side
Trim
Screw
Spring to Accommodate
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
CAUTION:
slippery. Grip the metal panel firmly so the panel
does not slip out of the frame and cause personal
injury or damage to the frame.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
14
Adjust Nut Below
Panel Weight
The metal panel may be
Loosen
Side
Trim
Screw