Step 11A Install Overlay Panels - Monogram ZISB36 Series Installation Instructions Manual

Installation Instructions - Standard Installation

STEP 11A INSTALL OVERLAY PANELS

Install door panels:
• Open door to 90°.
• Remove the 6 screws holding the door trim on the
handle side, then lift off the trim. Retain the screws.
• Slide the overlay panel into the door trim.
Dispenser Models Only:
• IMPORTANT: The dispenser controls protrude
beyond the face of the freezer door. To avoid damage
to the dispenser, the trim at the top of the door should
be removed.
• Remove the screws holding the top trim in place.
• Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim.
• Reinstall the top trim piece with all of the original
screws.
All Models
• There are two sets of holes in the door trim on the
handle side. Replace door trim by installing the
original screws in the REAR screw holes.
• Secure the visor handle option kit ZKLN to the door
using the FRONT screw holes.
• Follow the same procedures to install the opposite
panel.
• Check to be sure the handles are evenly aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
Optional
Visor
Handle from
kit ZKLN
Move
Forward
for 3/4"
Panel
Top Trim
22
Door Trim
Refrigerator
Door
Visor Handel from kit
ZKLN shown in Overlay
Panel Position
Use Front Holes
to Secure Visor
Handle from
optional kit ZKLN
Use Rear Holes
to Secure Door
Trim
31-1000450 Rev. 1