Table of Contents
Advertisement
DISPENSER MODELS:
RAISED OVERLAY PANEL DESIGN
When a raised panel design is to be used,
a custom wide middle rail is required to accept
the dispenser trim.
• The middle rail must be wide enough to allow
for the dispenser trim to overlap the opening.
• The middle rail must be 28 mm total thickness
to accept the dispenser trim.
DISPENSER TRIM FIT EXAMPLES:
(NOT TO SCALE)
6 mm FRAMED PANEL
• The dispenser trim fits over the custom
panel and snaps into the freezer door.
• The clips will not engage the door
if the panel is more than 6 mm thick.
• If the panel is less than 6 mm thick,
a noticeable gap may be created
around the dispenser trim.
19 mm OVERLAY PANEL
• The dispenser trim fits over the custom
panel and snaps into the freezer door.
• The clips will not engage the door
if the panel is more than 28 mm thick.
• If the panel is less than 28 mm thick,
a noticeable gap may be created
around the dispenser trim.
Design Guide
Dispenser
Trim
425 mm
270 mm
6 mm
Framed
Panel
6 mm Backer Panel
3 mm Spacer
Panel
19 mm Overlay
Panel
19 mm Overlay Dispenser Trim
9
6 mm Backer Panel
3 mm Spacer
19 mm Overlay Panel
Middle
Rail is
Required
FREEZER DOOR
Ice / Water Dispenser
6 mm Dispenser Trim
FREEZER DOOR
Ice / Water Dispenser
Wide
6 mm
Thick
28 mm
Total Thickness
Advertisement
Table of Contents
