Step 9A Install Overlay Panels - Monogram ZIS360N Installation And Design Manual

STEP 9A INSTALL OVERLAY PANELS

Install door panels:
• Open door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove handle. Retain all screws.
• Remove 6 screws holding trim, lift off trim. Retain
screws.
• Slide overlay panel into the door trim.
Dispenser Models Only:
• The dispenser controls protrude beyond the face of the
freezer door. To avoid damage to the dispenser, the
trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim.
• Reinstall the top trim piece with screws.
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the REAR screw holes.
• Secure the handle to the door using the FRONT screw
holes.
• Follow the same procedures to install the opposite
panel.
Custom handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door trims using both the FRONT and
REAR screw holes. Discard supplied handles.
Installation Instructions
16
Door Trim
Handle
Trim
Refrigerator
Door
Move
Forward
For 3/4"
Panel
Supplied Handle
Shown in Overlay
Panel Position
Use Front Holes
to Secure Handle
Use Rear Holes
to Secure Trim