Table of Contents
Advertisement
SIDE PANELS
Side panels must be used
whenever the sides of the
refrigerator will be exposed.
The 6 mm side panels will
slip into the side case trim.
Secure the panels to the
refrigerator with stick-on
hook and loop fastener
strips. Order the side
panels from the cabinet
manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
TOOLS AND MATERIALS REQUIRED
• Tin snips to cut banding
• Stepladder
• 1" Bit extenion
• Tape measure
• 1/4" Drywall screws
• Bucket
• Level
• Appliance hand truck
• Tubing cutter
• 7/16" Open-end wrench
• #2 Phillips screwdriver
• Drill and appropriate bits
• 5/16", 7/16" Socket
• Safety glasses
• 1-1/8" Open-end wrench
• Pliers
• 1/4", 5/16" Combo ratchet
• 900 mm x 50 mm x 100 mm Wood block
for Anti-Tip support
• Supplied water line kit or GE SmartConnect
Refrigerator Tubing kits
• Water shut-off valve
• Custom panels for doors and grille panel
• Screws to secure refrigerator to cabinetry
• Stick-on hook and loop fastener strips for
6 mm side panels
HARDWARE SUPPLIED
• Water filter bypass plug
• Anti-Tip brackets
• 1/4" nut and ferrule
• Dispenser trims for 6 mm and 19 mm overlay panels
• 12 pan-head screws for custom handle installation
Design Guide
610
mm
5 mm
48 mm
*2134 mm
*76 mm to
102 mm
65 mm
* Depending on installation height.
™
FLOORING
For proper installation, this refrigerator must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should be
strong enough to support a fully loaded refrigerator, or
approximately 680 kg.
NOTE: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under the
refrigerator where you are working.
EARTHING THE REFRIGERATOR
IMPORTANT—(Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY EARTHED.
The power cord of this appliance is equipped with an
earthing plug which mates with a standard earthed
wall receptacle to minimize the possibility of electric
shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly earthed.
Where an unearthed wall outlet is encountered, it is
your personal responsibility and obligation to have
it replaced with a properly earthed wall outlet.
IMPORTANT: The refitting of
electric plugs and cables should
be done by a qualified technician
or service agent. In some countries
the refitting of electric plugs and
cables is only permitted when the
work is completed by a qualified
technician.
NOTE: Plug type shown may not
match to the plug on your refrigerator
depending on the country of the sale.
Mains lead replacement
If the mains lead on your refrigerator needs
replacing at any time, it must be replaced by a
special lead which is obtainable from your local
dealer. A charge will be made for the replacement
of the mains lead if you have damaged the lead.
Unplug the unit or turn off the main switch on the
switchboard before servicing or repairing the
refrigerator. To unplug the unit, pull the refrigerator
away from the wall and then unplug it.
10
Ensure proper
earthing
exists
before
using.
Earthing
Plug
Advertisement
Table of Contents
