Table of Contents
Advertisement
STEP 12 INSTALL FRAMED PANELS
Install door panels:
• Open the door to 90°. Remove the 6 Phillips-head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, then lift off
the trim. Retain the screws.
• Slide the framed panel into the door trim.
Dispenser Models Only:
• The dispenser controls protrude beyond the face
of the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the freezer panel into the bottom channel
and slide into the hinge side trim.
• Reinstall the top trim piece with screws.
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in the FRONT screw holes.
• Secure the handle to the door using the REAR screw
holes.
• Follow the same procedures to install the opposite panel.
• Check to be sure the handles are evenly aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
NOTE: Aluminum cover trim is supplied for use with
custom handles on overlay panels. It is not intended for
use with 6 mm panels. Discard the cover trim when using
6 mm framed panels.
Installation Instructions
15
Go to Step 10A for Overlay Panels
Handle
Trim
Supplied Handle
Shown in 6 mm
Panel Position
Door Trim
Refrigerator
Door
Use Front Holes
to Secure Trim
Use Rear Holes
to Secure Handle
Advertisement
Table of Contents
