Step 4, Household Water Filtration; Step 5 Install Side Panels; Step 6 Install Anti-Tip Brackets - Monogram ZPB480D Installation Instructions Manual

STEP 4 INSTALLATION WITH
HOUSEHOLD WATER
FILTRATION SYSTEM
Skip this step if you do not have a household water
filtration system.
If the water supply to the refrigerator is from
any household water filtration system, the filter
cartridge should be removed. For better ice and water
performance, remove the filter and install the filter
bypass plug.
Rotate Clockwise To Remove

STEP 5 INSTALL SIDE PANELS

Skip this step when not using side panels.
If you are using 6 mm side panels, they should
be inserted into the case trim. Fasten the panels
to the refrigerator with stick-on hook and loop
fastener strips before setting the refrigerator in place.
Installation Instructions
Filter Bypass Plug
12

STEP 6 INSTALL ANTI-TIP BRACKETS

WARNING:
The refrigerator is top-heavy and must be secured
to prevent the possibility of tipping forward.
• Cut a 50 mm x 100 mm x 900 mm wood block.
Secure the block to the mounting brackets provided
using 6 mm diameter wood screws.
50 x 100 mm
Cut 900 mm
Length
Installation
Height
From Floor
Screws Mounted into
Vertical Wall Studs
• Secure the bracket with the wood block to the back
wall so that it is 2134 mm (or your installation height)
from the finished floor. Use 6 mm diameter wood
screws.
Block
Brackets
Required
Height
From
Floor
to
Bottom
of Wood
Block
Side View
• The screws must penetrate at least 25 mm
into the vertical wall studs.
Connect power cord:
• Before pushing the refrigerator into the opening, plug
the power cord into the receptacle. Open the grille
panel and reach into the opening at the back to grasp
the power cord. Pull the power cord into the opening
as you push the refrigerator back.
• Gently push refrigerator into the opening with hands
against front corners.
IMPORTANT NOTE:
When the refrigerator is installed under a soffit
or if there is not enough height for this method of security, brackets
cannot be used. Proceed to Step 7 to level the refrigerator and then to
Step 9 to secure refrigerator to cabinets. See Step 8 if you have metal
wall studs. The refrigerator must be secured to prevent tipping.
ANTI-TIP PRECAUTIONS
Mounting
Bracket
Soffit
Brackets
Not Required
Beneath a
Soffit