Step 9A, Install Overlay Panels - Monogram ZIS360N Installation Instructions Manual

Installation Instructions
STEP 9A| INSTALL OVERLAY PANELS
Door Trim
Handle
Trim
Refrigerator
Door
Move
Forward
For 3/4"
Panel
Supplied Handle
Shown in Overlay
GP) Ps | PSS
& lo. Ore dag
fe lot | ae o
» o f ge 0
we p h ieee
Uy
® Ue os
Install door panels:
¢ Open door to 90°. Remove the 6 Phillips head screws
from the door handle.
¢ Remove handle. Retain all screws.
¢ Remove 6 screws holding trim, lift off trim. Retain
screws.
¢ Slide overlay panel into the door trim.
Dispenser Models Only:
¢ The dispenser controls protrude beyond the face of
the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.
¢ Remove the screws holding the top trim in place.
¢ Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim.
¢ Reinstall the top trim piece with screws.
¢ There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the REAR screw holes.
¢ Secure the handle to the door using the FRONT screw
holes.
¢ Follow the same procedures to install the opposite
panel.
¢ Check to be sure handles are evenly aligned with each
other at the top. To adjust, loosen handle screws and
slide up or down. Tighten screws.
Panel Position
7 Use Front Holes
SL to Secure Handle
Oe ~~ "Use Rear Holes
to Secure Trim
Custom handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel
into the trim.
¢ The cabinet manufacturer will supply the custom
handle and hardware.
¢ Secure the door trims using both the FRONT and
REAR screw holes. Use pan head screws to secure the
trim. A package of 12 extra pan head screws can be
found in the literature package. Discard supplied
handles.
16