Table of Contents
Advertisement
19 mm OVERLAY PANEL DIMENSIONS
For a more custom appearance, overlay panels may
be installed on trimmed models. The overlay panel must
be secured to a 6 mm thick backer panel which slides
into the trim. A spacer panel 3 mm thick must be placed
between the overlay and backer panel.
Assemble the panels with glue and screws:
• Center the spacer panel on the backer panel, left to
right and top to bottom. Secure the panels with glue.
• Center the spacer and backer panel on the overlay
panel and secure with glue and screws. Screws must
be countersunk into the backer panel.
IMPORTANT NOTE – DISPENSER MODELS
The refrigerator is supplied with two dispenser trims,
one for framed panels and one for overlay panels. The
overlay dispenser trim is designed to fit a total panel
thickness of 28 mm.
• If the panel is less than 28 mm a noticeable gap may
be created around the dispenser trim.
• If the panel is more than 28 mm the dispenser trim
cannot be secured to the door.
See Dispenser Trim Fit Examples, page 9.
A
Grille Panel
F
Dispenser
Cutout
G
Freezer
Fresh Food
Panel
Panel
D
E
Design Guide
Dispenser Cutout
B
391 mm
244 mm
C
42" Side-by-Side (in millimeters)
A
6 mm Backer Panel 1013 mm 241 mm 1737 mm 370 mm 624 mm
3 mm Spacer Panel 991 mm
19 mm Overlay Panel 1019 mm 248 mm 1743 mm 376 mm 630 mm 456 mm 133 mm
48" Side-by-Side (in millimeters)
A
6 mm Backer Panel 1165 mm 241 mm 1737 mm 472 mm 699 mm
3 mm Spacer Panel 1143 mm 219 mm 1702 mm 438 mm 641 mm
19 mm Overlay Panel 1172 mm 248 mm 1743 mm 462 mm 681 mm 456 mm 133 mm
Door
19 mm
Overlay
Panel
6 mm
3 mm
Backer
Spacer
Panel
6 mm + 3 mm + 19 mm = 28 mm Total Panel Thickness
• The overlay panel must be constructed according to
the specifications shown to achieve the correct total
thickness.
• Alternative panel construction methods such as
securing a 19 mm panel to a 6 mm backer panel
cannot be used. Another method, routing a 19 mm
thick panel on all sides, cannot be used. These
methods will not result in the required 28 mm panel
thickness.
When a raised panel design is to be used, a custom
middle rail is required. See page 9 for details.
*Cut the dispenser opening after the backer, spacer and overlay
panels have been assembled.
IMPORTANT NOTE: Maximum total weight for the assembled
panels:
•
Fresh food door panel – 34 kg.
•
Freezer door panel – 24 kg.
•
Grille Panel – 8 kg.
B
C
D
219 mm 1702 mm 337 mm 591 mm
B
C
D
8
Overlay Panel
Spacer Panel
Backer Panel
NOTE: Left-to-right offset is not
always equal to top-to-bottom
offset.
*Dispenser
Cutout Position
E
F
G
*Dispenser
Cutout Position
E
F
G
Advertisement
Table of Contents
