Step 9A Install Overlay Panels - Monogram ZIFS360NHRH Installation Instructions Manual

Installation Instructions - Standard Installation

STEP 9A INSTALL OVERLAY PANELS

Install Door Panel:
• Open the door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, lift off the trim.
Retain the screws.
• Slide the overlay panel into the door trim.
Custom Handles
If you are using custom handles, the handle must
be properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door trim using new handle side trim.
Discard the supplied handle.
Use Front Holes
to Secure Handle
Use Rear Holes
to Secure Trim
20
Right hand models shown. Use the same instructions
for left hand models.
Handle
Trim
Move
Forward
For 3/4"
Panel
Supplied handle shown
in the overlay panel position.
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in the REAR screw holes.
• Secure the handle to the door using the FRONT
screw holes.
Door Trim
Door