Vrrp-Track-Interface Management Collaboration Configuration Example - HPE FlexFabric 5700 Series Configuration Manual

Ping 30.1.1.1: 56
Reply from 30.1.1.1: bytes=56 Sequence=1 ttl=254 time=2 ms
Reply from 30.1.1.1: bytes=56 Sequence=2 ttl=254 time=1 ms
Reply from 30.1.1.1: bytes=56 Sequence=3 ttl=254 time=1 ms
Reply from 30.1.1.1: bytes=56 Sequence=4 ttl=254 time=2 ms
Reply from 30.1.1.1: bytes=56 Sequence=5 ttl=254 time=1 ms
--- Ping statistics for 30.1.1.1 ---
5 packet(s) transmitted, 5 packet(s) received, 0.00% packet loss
round-trip min/avg/max/std-dev = 1/1/2/1 ms
# Verify that the hosts in 30.1.1.0/24 can communicate with the hosts in 20.1.1.0/24 when the master
route fails.
[SwitchB] ping -a 30.1.1.1 20.1.1.1
Ping 20.1.1.1: 56
Reply from 20.1.1.1: bytes=56 Sequence=1 ttl=254 time=2 ms
Reply from 20.1.1.1: bytes=56 Sequence=2 ttl=254 time=1 ms
Reply from 20.1.1.1: bytes=56 Sequence=3 ttl=254 time=1 ms
Reply from 20.1.1.1: bytes=56 Sequence=4 ttl=254 time=1 ms
Reply from 20.1.1.1: bytes=56 Sequence=5 ttl=254 time=1 ms
--- Ping statistics for 20.1.1.1 ---
5 packet(s) transmitted, 5 packet(s) received, 0.00% packet loss
round-trip min/avg/max/std-dev = 1/1/2/1 ms
VRRP-Track-interface management collaboration
configuration example
Network requirements
As shown in
•
Host A requires access to Host B. The default gateway of Host A is 10.1.1.10/24.
•
Switch A and Switch B belong to VRRP group 1. The virtual IP address of VRRP group 1 is
10.1.1.10.
Configure VRRP-Track-interface management collaboration to monitor the uplink interface on the
master and meet the following requirements:
•
When Switch A operates correctly, it forwards packets from Host A to Host B.
•
When VRRP detects a fault on the uplink interface of Switch A through the interface
management module, Switch B forwards packets from Host A to Host B.
data bytes, press CTRL_C to break
data bytes, press CTRL_C to break
Figure 49:
195