Displaying And Maintaining Rrpp; Rrpp Configuration Examples; Single Ring Configuration Example - HPE FlexFabric 5700 Series Configuration Manual

Step
1. Enter system view.
2. Create an RRPP ring group
and enter RRPP ring group
view.
3. Assign the specified subrings
to the RRPP ring group.

Displaying and maintaining RRPP

Execute display commands in any view and reset commands in user view.
Task
Display brief RRPP information.
Display RRPP group configuration information.
Display RRPPDU statistics.
Display detailed RRPP information.
Clear RRPPDU statistics.

RRPP configuration examples

Single ring configuration example

Network requirements
As shown in
•
Device A, Device B, Device C, and Device D form RRPP domain 1. Specify the primary control
VLAN of RRPP domain 1 as VLAN 4092. Specify the protected VLANs of RRPP domain 1 as
VLANs 1 through 30.
•
Device A, Device B, Device C, and Device D form primary ring 1.
•
Specify Device A as the master node of primary ring 1, Ten-GigabitEthernet 1/0/1 as the primary
port, and Ten-GigabitEthernet 1/0/2 as the secondary port.
•
Specify Device B, Device C, and Device D as the transit nodes of primary ring 1. Specify
Ten-GigabitEthernet 1/0/1 as the primary port and Ten-GigabitEthernet 1/0/2 as the secondary
port on Device B, Device C, and Device D.
Command
system-view
rrpp ring-group ring-group-id
domain domain-id ring ring-id-list
Figure 19:
Command
display rrpp brief
display rrpp ring-group [ ring-group-id ]
display rrpp statistics domain domain-id [ ring
ring-id ]
display rrpp verbose domain domain-id [ ring
ring-id ]
reset rrpp statistics domain domain-id [ ring
ring-id ]
58
Remarks
N/A
By default, no RRPP ring group is
created.
By default, no subrings are
assigned to an RRPP ring group.