Configuring Rrpp Rings; Configuring Rrpp Ports - HPE FlexFabric 5700 Series Configuration Manual

Step
3. Configure the
VLAN-to-instance mapping
table.
4. Activate MST region
configuration.
5. (Optional.) Display the
currently activated
configuration information of
the MST region.
6. Return to system view.
7. Enter RRPP domain view.
8. Configure protected VLANs
for the RRPP domain.

Configuring RRPP rings

When you configure an RRPP ring, you must configure the ports connecting each node to the RRPP
ring before configuring the nodes.

Configuring RRPP ports

Follow these guidelines when you configure RRPP ports:
•
Do not enable the OAM remote loopback function on an RRPP port. Otherwise, temporary
broadcast storms might occur.
•
To accelerate topology convergence, use the link-delay command to enable link status rapid
report function on an RRPP port. Use this command to set the physical state change
suppression interval to 0 seconds. For more information about the link-delay command, see
Layer 2—LAN Switching Command Reference.
Perform this task on each node's ports intended for accessing RRPP rings.
To configure RRPP ports:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
Command
•
Method 1:
instance instance-id vlan
vlan-id-list
•
Method 2:
vlan-mapping modulo
modulo
active region-configuration
display stp
region-configuration
quit
rrpp domain domain-id
protected-vlan
reference-instance
instance-id-list
Command
system-view
interface interface-type
54
Remarks
Use either method.
By default, all VLANs in an MST
region are mapped to MSTI 0 (the
CIST).
Not required if the device is
operating in PVST mode.
For more information about the
commands, see Layer 2—LAN
Switching Command Reference.
Not required if the device is
operating in PVST mode.
For more information about the
command, see Layer 2—LAN
Switching Command Reference.
Available in any view.
The output of the command
includes VLAN-to-instance
mappings.
For more information about the
command, see Layer 2—LAN
Switching Command Reference.
Not required if the device is
operating in PVST mode.
N/A
By default, no protected VLAN is
configured for an RRPP domain.
Remarks
N/A
N/A