Step
2.
Enter interface view.
3.
Configure the VFs in a VRRP
group to monitor a track
entry.
Configuring IPv6 VRRP packet attributes
This section describes how to configure IPv6 VRRP packet attributes.
Configuration guidelines
•
The routers in an IPv6 VRRP group can have different intervals for sending VRRP
advertisements. The master in the VRRP group sends VRRP advertisements at the specified
interval and carries the interval attribute in the advertisements. After a backup receives the
advertisement, it records the interval in the advertisement. If the backup does not receive a new
VRRP advertisement from the master before the timer (3 x recorded interval + Skew_Time)
expires, it regards the master as failed and takes over as the new master.
•
A high volume of network traffic might cause a backup to fail to receive VRRP advertisements
from the master within the specified time, resulting in an unexpected master switchover. To
solve this problem, configure a larger interval.
Configuration procedure
To configure the IPv6 VRRP packet attribute:
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure the IPv6 VRRP
advertisement interval.
4.
Return to system view.
5.
Configure a DSCP value for
IPv6 VRRP packets.
Command
interface interface-type
interface-number
vrrp ipv6 vrid virtual-router-id
track track-entry-number
{ forwarder-switchover
member-ip ipv6-address |
priority reduced
[ priority-reduced ] | switchover |
weight reduced
[ weight-reduced ] }
Command
system-view
interface interface-type
interface-number
vrrp ipv6 vrid virtual-router-id
timer advertise adver-interval
quit
vrrp ipv6 dscp dscp-value
134
Remarks
N/A
By default, the VF tracking
function is not configured.
Remarks
N/A
N/A
The default setting is 100
centiseconds.
As a best practice to maintain
system stability, set the VRRP
advertisement interval to be
greater than 100 centiseconds.
N/A
The DSCP value identifies the
packet priority during
transmission.
By default, the DSCP value for
IPv6 VRRP packets is 56.