Vrrp Load Balancing Configuration Example - HPE FlexFabric 5700 Series Configuration Manual

VRRP load balancing configuration example

Network requirements
Switch A, Switch B, and Switch C form a load-balanced VRRP group and use the virtual IP address
10.1.1.1/24 to provide gateway service for subnet 10.1.1.0/24, as shown in
Configure VFs on Switch A, Switch B, and Switch C to monitor their respective VLAN-interface 3.
When the interface on any one of them fails, the weights of the VFs on the problematic switch
decrease so another AVF can take over.
Figure 39 Network diagram
Configuration procedure
1. Configure Switch A:
# Configure VLAN 2.
<SwitchA> system-view
[SwitchA] vlan 2
[SwitchA-vlan2] port ten-gigabitethernet 1/0/5
[SwitchA-vlan2] quit
# Configure VRRP to operate in load balancing mode.
[SwitchA] vrrp mode load-balance
# Create VRRP group 1, and set its virtual IP address to 10.1.1.1.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address 10.1.1.2 24
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1
# Assign Switch A the highest priority in VRRP group 1, so Switch A can become the master.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 120
141
Figure 39.