Displaying And Maintaining Monitor Link; Monitor Link Configuration Example - HPE FlexFabric 5700 Series Configuration Manual

Displaying and maintaining Monitor Link

Execute the display command in any view:
Task
Display monitor link group information.

Monitor Link configuration example

Network requirements
As shown in
•
Device C is a Smart Link device, and Device A, Device B, and Device D are associated devices.
Traffic of VLANs 1 through 30 on Device C is dual-uplinked to Device A through a smart link
group.
•
Implement dual uplink backup on Device C. When the link between Device A and Device B (or
Device D) fails, Device C can detect the link fault and perform uplink switchover in the smart link
group.
For more information about Smart Link, see
Figure 28 Network diagram
Device B
Configuration procedure
1. Configure Device C:
# Create VLANs 1 through 30.
<DeviceC> system-view
[DeviceC] vlan 1 to 30
# Map these VLANs to MSTI 1.
[DeviceC] stp region-configuration
[DeviceC-mst-region] instance 1 vlan 1 to 30
# Activate MST region configuration.
[DeviceC-mst-region] active region-configuration
[DeviceC-mst-region] quit
# Shut down Ten-GigabitEthernet 1/0/1.
[DeviceC] interface ten-gigabitethernet 1/0/1
Figure 28:
Device A
Device C
Command
display monitor-link group { group-id | all }
"Configuring Smart Link."
Device D
113