Rrpp Configuration Task List; Creating An Rrpp Domain; Configuring Control Vlans - HPE FlexFabric 5700 Series Configuration Manual

RRPP configuration task list

You can configure RRPP in the following order:
•
Create RRPP domains based on service planning.
•
Specify control VLANs and data VLANs for each RRPP domain.
•
Determine the ring roles and node roles based on the traffic paths in each RRPP domain.
RRPP does not have an auto election mechanism. You must configure each node in the ring network
correctly for RRPP to monitor and protect the ring network.
Before you configure RRPP, you must physically construct a ring-shaped Ethernet topology.
To configure RRPP, perform the following tasks:
Tasks at a glance
(Required.)
(Required.)
(Required.)
(Required.)
•
Configuring RRPP ports
•
Configuring RRPP nodes
(Required.)
(Optional.) Configuring RRPP timers
(Optional.) Configuring an RRPP ring group

Creating an RRPP domain

When you create an RRPP domain, specify a domain ID to uniquely identify the RRPP domain. All
devices in the same RRPP domain must be configured with the same domain ID.
Perform this task on devices you want to configure as nodes in the RRPP domain.
To create an RRPP domain:
Step
1. Enter system view.
2. Create an RRPP domain and
enter RRPP domain view.

Configuring control VLANs

Before you configure RRPP rings in an RRPP domain, configure the same control VLANs for all
nodes in the RRPP domain first. You need only configure the primary control VLAN for an RRPP
domain. The system automatically configures the secondary control VLAN. It uses the primary
control VLAN ID plus 1 as the secondary control VLAN ID. For the control VLAN configuration to
succeed, make sure the IDs of the two control VLANs are consecutive and have not been previously
assigned.
Creating an RRPP domain
Configuring control VLANs
Configuring protected VLANs
Configuring RRPP rings:
Activating an RRPP domain
Remarks
Perform this task on all nodes in the RRPP domain.
Perform this task on all nodes in the RRPP domain.
Perform this task on all nodes in the RRPP domain.
Perform this task on all nodes in the RRPP domain.
Perform this task on all nodes in the RRPP domain.
Perform this task on all nodes in the RRPP domain.
Perform this task on the master node in the RRPP
domain.
Perform this task on the edge node and assistant edge
node in the RRPP domain.
Command
system-view
rrpp domain domain-id
52
Remarks
N/A
By default, no RRPP domain
is created.