Configuring Ipv6 Vrrp; Ipv6 Vrrp Configuration Task List; Specifying An Ipv6 Vrrp Operating Mode - HPE FlexFabric 5700 Series Configuration Manual

Task
groups.
Clear statistics for IPv4 VRRP
groups.

Configuring IPv6 VRRP

This section describes how to configure IPv6 VRRP.

IPv6 VRRP configuration task list

Tasks at a glance
(Required.)
operating mode
(Required.)
assigning a virtual IPv6 address
(Optional.) Configuring the router priority,
preemptive mode, and tracking function
(Optional.) Configuring VF tracking
(Optional.) Configuring IPv6 VRRP packet
attributes
(Optional.) Disabling an IPv6 VRRP group

Specifying an IPv6 VRRP operating mode

A VRRP group can operate in either of the following modes:
•
Standard mode—Only the master can forward packets.
•
Load balancing mode—All members that have an AVF can forward packets.
After the IPv6 VRRP operating mode is specified on a router, all IPv6 VRRP groups on the router
operate in the specified operating mode.
To specify an IPv6 VRRP operating mode:
Step
1. Enter system view.
2. Specify an IPv6 VRRP
operating mode.
Specifying an IPv6 VRRP
Creating a VRRP group and
Command
system-view
•
•
Command
[ vrid virtual-router-id ] ]
reset vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Remarks
N/A
N/A
N/A
This configuration applies only to VRRP load balancing
mode.
N/A
N/A
Specify the standard mode:
undo vrrp ipv6 mode
Specify the load balancing
mode:
vrrp ipv6 mode
load-balance
131
Remarks
N/A
By default, VRRP operates in
standard mode.