Configuring Ipv4 Vrrp; Ipv4 Vrrp Configuration Task List; Specifying An Ipv4 Vrrp Operating Mode; Specifying The Ipv4 Vrrp Version - HPE FlexFabric 5700 Series Configuration Manual

Configuring IPv4 VRRP

This section describes how to configure IPv4 VRRP.

IPv4 VRRP configuration task list

Tasks at a glance
(Required.)
(Optional.)

Specifying the IPv4 VRRP version

(Required.)
(Optional.) Configuring the router priority, preemptive mode, and
tracking function
(Optional.) Configuring IPv4 VRRP packet attributes
(Optional.) Configuring VF tracking
(Optional.) Enabling SNMP notifications for VRRP
(Optional.) Disabling an IPv4 VRRP group

Specifying an IPv4 VRRP operating mode

A VRRP group can operate in either of the following modes:
•
Standard mode—Only the master can forward packets.
•
Load balancing mode—All members that have an AVF can forward packets.
After an IPv4 VRRP operating mode is configured on a router, all IPv4 VRRP groups on the router
operate in the specified operating mode.
To specify an IPv4 VRRP operating mode:
Step
1. Enter system view.
2. Specify an IPv4 VRRP
operating mode.
Specifying the IPv4 VRRP version
The VRRP version on all routers in an IPv4 VRRP group must be the same.
To specify the version of IPv4 VRRP:
Step
1. Enter system view.
2. Enter interface view.
Specifying an IPv4 VRRP operating mode
Creating a VRRP group and assigning a virtual IP address
Command
system-view
•
•
Command
system-view
interface interface-type interface-number
Specify the standard mode:
undo vrrp mode
Specify the load balancing
mode:
vrrp mode load-balance
[ version-8 ]
126
Remarks
N/A
N/A
N/A
N/A
N/A
This configuration applies only to
VRRP load balancing mode.
N/A
N/A
Remarks
N/A
By default, VRRP operates in
standard mode.
Remarks
N/A
N/A