Smart Link Configuration Examples; Single Smart Link Group Configuration Example - HPE FlexFabric 5700 Series Configuration Manual

Task
Display information about the received flush
messages.
Display smart link group information.
Clear the statistics about flush messages.

Smart Link configuration examples

Single smart link group configuration example

Network requirements
As shown in
•
Device C and Device D are Smart Link devices. Device A, Device B, and Device E are
associated devices. Traffic of VLANs 1 through 30 on Device C and Device D is dually uplinked
to Device A.
•
Configure Smart Link on Device C and Device D for dual uplink backup.
Figure 24 Network diagram
Configuration procedure
1. Configure Device C:
# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region
configuration.
<DeviceC> system-view
[DeviceC] vlan 1 to 30
[DeviceC] stp region-configuration
[DeviceC-mst-region] instance 1 vlan 1 to 30
[DeviceC-mst-region] active region-configuration
[DeviceC-mst-region] quit
Figure 24:
Command
display smart-link flush
display smart-link group { group-id | all }
reset smart-link statistics
96