Table of Contents
Advertisement
Wireless IAD User Manual
This page provides some settings for you to adjust for adding a new
outbound IP Filtering.
Allow Traffic：
Choose No to stop the data transmission, Yes to permit the data pass
through.
Protocol：
Here provides several default policies for security levels for you to choose.
If you don't want to use the predefined setting, you can use User Defined to
set a customized protocol according to the necessity.
Source/Destination IP address：
To specify IP address to allow or deny data transmission, please pull down
the drop-down menu to choose a proper one.
The setting All means that all the IP addressed in the network are allowed or
denied to pass through in Internet.
If you choose Single, you will have to key in the specific IP address as the
start/end point to let the router identify for granting or denying passing
through.
If you choose Subnet, you will have to enter the specific IP address and
netmask as the start/end point to let the router identify for granting or
denying passing through.
Port Range：
The port range is from 0 to 65535. Please key in the start point and end point
for the IP Filtering.
After finish the settings, click Apply.
Here provides an example shown in the right column. Select TCP as the
Protocol type, and make the Source and Destination IP address to include
All, then type 0 and 65535 as the start and end port.
81
Advertisement
Table of Contents
