Table of Contents
Advertisement
Use the following DNS Server Address, then key in the information
that your ISP offered, e.g.:
WAN IP Address: 10.3.95.233
WAN Subnet Mask: 255.255.255.248
Primary DNS server: 168.95.1.1
Secondary DNS server: 168.95.192.1
Uncheck Enable NAT and click Next.
(5). On the Configure LAN side Settings page, key in the information for
your LAN, e.g.,
Primary IP Address: 192.168.1.1
Subnet mask: 255.255.255.0
Start IP Address: 192.168.1.2
End IP Address: 192.168.1.254
Check Configure the second IP Address and Subnet Mask for LAN
(6).
Interface and enter the information needed.
Secondary IP Address: 10.3.80.81
Subnet mask: 255.255.255.248
Click Next.
Check the network information on the Summary page. Make sure the
(7).
settings match the settings provided by your ISP. Click Finish.
Refer to the TCP/IP properties, specify an IP Address, and fill in other
(8).
information needed, e.g.:
IP Address: 10.3.80.82
Subnet Mask: 255.255.255.248
Gateway: 10.3.80.81
Preferred DNS server: 168.95.1.1
Now the IAD is well-configured. You can access the Internet.
(9).
Wireless IAD User Manual
34
Advertisement
Table of Contents
