Table of Contents
Advertisement
Wireless IAD User Manual
–
Firewall
MAC Filtering
The bridge filtering mechanism provides a way for the users to define rules
to allow/deny packets through the bridge based on source MAC address
and/or destination MAC address. When bridge filtering is enabled, each
packet is examined against the each defined filter rules sequentially, and
when a matched is determined, the packets will be blocked.
This page allows you to define the bridge packet filtering rules to block
those redundant packets with specific protocols and MAC addresses.
Select traffic direction from the drop down menu, and check the network
interface which you want this rule to apply on. Then, choose a protocol and
define the source or destination MAC address which you want to control.
For example, if we choose Outbound, check br_0_35, select PPPoE as
protocol, and enter 00:90:96:01:2A:C3 into the Source MAC Address field,
then after clicking Apply, we will see the result as shown in the right.
You can use Add or Delete button to maintain the bridge filtering rules.
79
Advertisement
Table of Contents
