Table of Contents
Advertisement
2.
After powering off the product, power on the product at least 15 seconds later.
3.
Do not block the ventilating openings of this product.
4.
When the product is expected to be not in use for a period of time, unplug the power cord
of the product to prevent it from the damage of storm or sudden increases in rating.
Do not attempt to disassemble or open covers of this unit by yourself. Nor should you attempt
to service the product yourself, which may void the user's authority to operate it. Contact
qualified service personnel under the following conditions︰
1.
If the power cord or plug is damaged or frayed.
2.
If liquid has been spilled into the product.
3.
If the product has been exposed to rain or water.
4.
If the product does not operate normally when the operating instructions are
followed.
5.
If the product has been dropped or the cabinet has been damaged.
6.
If the product exhibits a distinct change in performance.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the authority to operate equipment.
F
F
C
F
F
C
This equipment must be installed and operated in accordance with provided instructions and a
minimum 20cm spacing must be provided between computer mounted antenna and person's
body (excluding extremities of hands, wrist and feet) during wireless modes of operation.
F
C
C
C
l
a
s
s
B
N
F
C
C
C
l
a
s
s
B
N
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
(1).
This device must accept any interference received, including interference that
(2).
may cause undesired operation.
Note︰
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment can
generate, use and radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures︰
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/television technician for help.
o
t
i
c
e
o
t
i
c
e
For Service
Caution
Wireless IAD User Manual
iii
Advertisement
Table of Contents
